RME Audio Advanced Remote Control Guide de l'utilisateur télécharger pdf (Page 12)

User's Guide Fireface UCX © RME

6. Hardware, Driver and Firmware Installation

6.1 Hardware and Driver Installation

To simplify installation it is recommended to first install the drivers before the unit is connected

to the computer. But it will also work the other way round.

Insert the RME Driver CD into your CD-ROM drive. The driver installer is located in the directory

\Fireface_USB or \Fireface_FW. Start rmeinstaller.exe and follow the instructions of the in-

staller. After installation connect computer and UCX using a USB or FireWire cable. Windows

detects the new hardware as Fireface UCX and installs the drivers automatically.

After a reboot, the icons of TotalMix FX and Settings dialog appear in

the notification area.

Driver Updates do not require to remove the existing drivers. Simply install the new driver over

the existing one.

Note

: FireWire and USB can be connected at the same time, but it is not recommended. Upon

start of the computer the port that becomes active first will be used. With no port active the unit

searches on both USB and FireWire until it finds an active one.

Possible reasons why a Fireface is not found automatically:

• The USB or FireWire port is not active in the system (check in Device Manager)

• The USB or FireWire cable is not, or not correctly inserted into the socket

6.2 De-installing the Drivers

A de-installation of the driver files is not necessary – and not supported by Windows anyway.

Thanks to full Plug & Play support, the driver files will not be loaded after the hardware has

been removed. If desired these files can then be deleted manually.

Unfortunately Windows Plug & Play methods do not cover the additional autorun entries of To-

talMix, the Settings dialog, and the registration of the ASIO driver. These entries can be re-

moved from the registry by a software de-installation request. This request can be found (like all

de-installation entries) in Control Panel, Software. Click on the entry 'RME Fireface'.

6.3 Firmware Update

The Flash Update Tool updates the firmware of the Fireface UCX to the latest version. It re-

quires an already installed driver.

Start the program fut_usb.exe. The Flash Update Tool displays the current revision of the Fire-

face firmware, and whether it needs an update or not. If so, then simply press the 'Update' but-

ton. A progress bar will indicate when the flash process is finished (Verify Ok).

After the update the unit needs to be reset. This is done by powering down the unit for a few

seconds. A reboot of the computer is not necessary.

When the update unexpectedly fails (status: failure), the unit's Safety BIOS will be used from

the next boot on, the unit stays fully functional. The flash process should then be tried again.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 111 112

Pas de commentaire

RME Audio Advanced Remote Control Guide de l'utilisateur Page 12